Mounting The Flow-Through-Chamber To The Drive Unit Unidrive X1000/X1000D - CAT UNIDRIVE X1000 Bedienungsanleitung

5.2

Mounting the Flow-Through-Chamber to the Drive Unit UNIDRIVE X1000/X1000D

Take care to avoid damage of parts during assembling respectively disassembling.
Only the Shafts G20 or G30 are suitable to be connected to the flow-through chamber DK 30;
different Generator versions are available (F, N, V and M).
 Remove locking ring (C), now you will see a spacing washer and an O-ring
 Remove thrust washer and O-ring
 Now assemble O-ring, thrust washer and locking ring (C) onto Shaft G20 or G30
 Be sure O-ring and spacing washer are in place -
 Insert Generator end of Shaft G20 or G30 into chamber
 Carefully slide down O-ring, thrust washer and locking ring
 Screw locking ring in completely, to insure complete sealing -
 Push in Shaft G20 or G30 until it reaches the end of the chamber -
 Tighten fastening screw to secure Shaft G20 or G30. The inlet tube at the front end is
connected to the system. From the outlet tube at the side the product is pumped into a
container. It is possible to re-circulate, if necessary.
Instruction Manual UNIDRIVE X1000/X1000D 2011/08 V3.00
locking ring (C)
O-ring
Page/Seite 16 von/of 47