Attaching The Drive Unit To A Pedestal Stand; Inserting The Homogenizing Tool - CAT X120 Bedienungsanleitung

4.3.2 Attaching the drive unit to a pedestal stand

To ensure safe operation the drive units are mounted to a pedestal stand using a
cross over clamp. Vibrations may loosen the holding screws. Please check
periodically whether all holding screws are securely tight.
4.4

Inserting the homogenizing tool

The homogenizing tool comes always assembled. The connecting adapter (drive pin (11))
is located on the top of the shaft and is used to attach the shaft to the drive motor. When
inserting the homogenising tool, make sure that the coupling fits well. This can be easily
detected by the "click" that is heard when the coupling shaft has reached the end of the
coupling slot of the motor. Do not forget to securely fasten the holding screw (3).
drive pin (11)
Never run homogenising tools dry as the bearings and gaskets will be
damaged if the generator is not cooled by the medium. The distance between
the homogenising tool and the vessel bottom should not be less than 10mm.
The filling of the medium may not be less than about 55 mm. To avoid a
vortex it is necessary to insert the dispersing shaft out of the center of the
vessel. If these conditions are met the unit is ready for operation.
Bedienungsanleitung/Instruction Manual X120_2011/05 V1.04
stand rod (9)
cross over clamp (8)
knurled screw (10)
 Attach cross over clamp (8) to
the stand rod (9).
 Now attach the drive unit to the
stand by inserting the support
rod (6) into the free opening of
the cross over clamp (8).
 Tighten the knurled screw (10) of
the cross over clamp (8).
cross over clamp (8)
holding screw (3)
Page/Seite 8 von/of 31