Operation X120; Description Of The Speed Scale X120 230Volt Version - CAT X120 Bedienungsanleitung

4.5

Operation X120

Attention:
When connecting the instrument to an AC power outlet, ensure that your local
supply voltage matches that indicated on the instrument's rating plate.
Connect the unit to the mains.
The drive unit is turned on and off by means of the integral switch (1) at the motor housing.
With the integral switch (1) the speed can be steplessly adjusted.
Caution:
The integral switch (1) is only single-pole and is thus not suitable for safely
isolating the unit from the mains supply!
Before starting the unit make sure that
 the speed is set to the lowest speed
 the generator of the homogenising tool is inserted in the fluid. To avoid a vortex. it is
necessary to insert the dispersing shaft out of the centre of the vessel.
 the vessel is protected against rotating, shaking or moving
 make sure that the air ventilation slots are always open, as this is necessary for
cooling purposes
Start the unit always at the lowest speed and then gradually increase the speed to the
desired level.
Never exceed the maximum operation time of 3 minutes in one go. Allow motor
and shaft to cool down. Disregard cause serious damage to drive unit and shaft.

4.5.1 Description of the speed scale X120 230Volt version:

Bedienungsanleitung/Instruction Manual X120_2011/05 V1.04
Start the unit always at the lowest
speed and then gradually increase
the speed to the desired level.
Page/Seite 9 von/of 31