Endress+Hauser RIA46 Bedienungsanleitung Seite 45

RIA46
Setup menu
No lin points
X-value
Y-value
Reset min/max
Calc value 2
See Calc value 1
 Analog out 1
Assignment
Signal type
Lower range
Upper range
 Analog out 2
See Analog out 1
 Relay 1
Assignment
Function
Set point
Set point 1/2
Time base
Hysteresis

Relay 2
See Relay 1
 Back
*) Is only displayed if "Application" = "Diff pressure" is configured.
Diagnostics menu
 Current diagn
 Last diagn
 Operating time

Diagnost logbook
 Device information
 Back
Endress+Hauser
Description
Number of linearization points
X-values for linearization points
Y-values for linearization points
Reset min/max values
Calculated value 2
Analog output 1
Assignment for analog output
Signal type of analog output
Lower range limit of analog output
Upper range limit of analog output
Analog output 2
Relay 1
Assignment of value to be monitored with relay
Operating function for relay
Set point for relay
Set points 1 and 2 for relay (only, if Function = Inband,
Outband)
Time base for gradient evaluation (only, if Function =
Gradient)
Hysteresis for relay
Relay 2
Return to main menu
Description
Current diagnostic
Last diagnostic
Operating time of the device
Diagnostics logbook
Device information
Return to main menu
Operation
45