Endress+Hauser RIA46 Bedienungsanleitung Seite 40

Operation
 A new device is detected and the Windows installation assistant opens.
2. In the installation assistant, do not carry out the automatic search for a driver. For this,
choose "No, not this time" and click "Next".
3. In the subsequent window, choose "Install from a list or specific location" and click "Next".
4. In the next window, click "Browse" and select the directory where the driver for the
TXU10/FXA291 adapter is located.
 The driver is installed.
5. Finish the installation by clicking "Finish".
6. A further device is detected and the Windows installation assistant opens once more.
Again, choose "No, not this time" and click "Next".
7. In the subsequent window, choose "Install from a list or specific location" and click "Next".
8. In the next window, click "Browse" and select the directory where the driver for the
TXU10/FXA291 adapter is located.
 The driver is installed.
9. Finish the installation by clicking "Finish".
The installation of the Windows driver for the interface adapter is now complete. Which
COM-Port has been assigned for the adapter can be seen in the Windows device manager.
Establishing the connection
To establish the connection with FieldCare, proceed as follows:
1. Firstly, edit the connection macro. For this, start a new project and in the window
displayed, click with the right mouse button on the symbol for "Service (CDI) FXA291"
and choose "Edit".
2. In the following window, next to "Serial interface", select the COM port which has been
assigned during the installation of the Windows driver for the TXU10/FXA291 adapter.
 The macro is now configured. Complete configuration by clicking "Finish".
3. Start the macro "Service (CDI) FXA291" by double-clicking it and confirm the subsequent
query with "Yes".
 A connected device is searched and the suitable DTM is automatically opened. The
configuration starts.
To then configure the device itself, follow these Operating Instructions for the device. The
entire Setup menu, i.e. all the parameters listed in these Operating Instructions, can also be
found in the FieldCare Device Setup.
In general, it is possible to overwrite parameters with the FieldCare PC software and the
appropriate device DTM even if access protection is active.
If access protection by means of a code should be extended to the software, this function
should be activated in the extended device setup.
For this purpose, select: Menu → Setup / Expert → System → Overfill protect → German
WHG and confirm.
40
RIA46
Endress+Hauser