Adjusting The Receiver Volume; Call Duration Display; Switching The Handset On And Off; Range Information - AUDIOLINE DECT8049 Bedienungsanleitung

4.6

Adjusting the receiver volume

If the receiver volume is too quiet or too loud for you, you can change this to suit your
requirements.
You can adjust the volume during a call by means of the
You can also increase the volume during a call with the
mobile unit. The amplification is switched off by pressing the button again. This amplification
is automatically set to off when the next call is made.
4.7

Call duration display

The call duration in minutes and seconds is shown in the display during a call. Fifteen
seconds after dialling, the display will switch from showing the number dialled to showing
the duration of the call. The call duration will still be retained in the display for a few seconds
after the call has been ended.
4.8

Switching the handset on and off

You can switch off the handset by pressing and holding the
switched off, no battery power will be used. It will not be possible to receive calls.
Press the button once to switch the handset on again. The display will show the
message BASE 1 and the handset will switch on again after a short time. The handset will
switch itself on automatically as soon as you replace it on the base station.
4.9

Range information

The range of the handset is ca. 50 metres in closed rooms and ca. 300 metres outdoors.
When there is a good contact with the base station, the
display.
If you are too far away from the base station, the
warning tones. In this case, move nearer to the base station once more, as otherwise the
call will be interrupted.
4.10

Muting the microphone in the handset

You can turn off the handset microphone during a call by using the display button Secrecy.
It is thus possible to speak without the other person hearing you. The loudspeaker in the
handset remains switched on and you can continue to hear the other person.
1. Press the display button Secrecy once during a call. The message Secrecy will appear
in the display.
2. To switch the microphone on again, press the display button Off once more. The MUTE
message will go off and you can continue the call as normal.
46
- Operation -
symbol will flash and you will hear
and buttons.
button on the left-hand side of the
button. If the handset is
symbol will come on in the