Kärcher CB 1/23 Eco Bedienungsanleitung Seite 34

107 Frequency converter of lifting motors,
switched off due to excess current in lift/
lower roof-brush
108 Frequency converter of lifting motors,
switched off due to excess current in lift/
lower drier
109 Under-voltage has occurred
110 Flow switch of brush washing has been
triggered
122 Control handle of drier allocated
123 Short/ narrow hall side 1 front key has
been pressed
124 Short/ narrow hall side 1 rear key has
been pressed
125 Short/ narrow hall side 2 front key has
been pressed
126 Short/ narrow hall side 2 rear key has
been pressed
127 Vehicle to broad on side 1 key has been
pressed
128 Vehicle to broad on side 2 key has been
pressed
139 Protective motor switch of fresh water
pump was triggered
141 Fault in frequency converter of lifiting motors,
switched off while operating roof brush
142 Fault in frequency converter of lifiting mo-
tors, switched off while operating drier
143 Fault in intensive cleaner
144 Fault in processed water
145 Fault in fresh water
146 Fault in osmosis water
147 Fault in rim cleaner
148 Filling level of foam too low
149 Filling level of shampoo too low
150 Filling level of drying aid too low
151 Filling level of hot wax too low
152 Filling level of insect cleaner too low
153 Filling level of polish too low
154 Filling level of chemicals 2 too low
155* Lack of water supply to high pressure
pumps
156* Protective motor switch high pressure
pump 1 was triggered
157* Protective motor switch high pressure
pump 2 was triggered
159* Thermal switch high pressure pump 1 was
triggered
160* Thermal switch high pressure pump 2 was
triggered
34
Lifting system of roof brush is difficult to
access
Lifting system of drier is difficult to access
Fluctuations in mains voltage
no water during brush washing
Check switching bracket and its limit
switch for damages
The switch has been pressed by a person Reset switch manually and press start key
Vehicle is too broad or has been posi-
tioned much to the left
Vehicle is too broad or has been posi-
tioned much to the right
Protective motor switch in the pump
switching cabinet was triggered
Lifting system of roof brush is difficult to
access
Lifting system of drier is difficult to access
Protective motor switch in the pump
switching cabinet was triggered
Fault in water preparation
Dry run of fresh water tank
Osmosis water tank empty; osmosis plant is
dective
Protective motor switch in the pump
switching cabinet was triggered
Detergent container almost empty
Water supply tank for high pressure
pumps empty
Protective motor switch in the pump
switching cabinet was triggered
Motor of high pressure pump 1 too hot or
defective
Motor of high pressure pump 2 is too hot
or defective
15
-
EN
Check lifting system, switch off and switch
on the unit, repeat washing process, call
Customer Service
Check power supply, switch on/ off the
unit, repeat washing process
Check supply of fresh and processed wa-
ter, repeat washing process
Repeat washing process, call Customer
Service
on the wash card reader to continue with
washing
Reposition the vehicle, reset the switch
manually, continue with washing by press-
ing the start key at the wash card reader or
repeat washing process
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
Check lifting system, switch off and switch
on the unit, repeat washing process, call
Customer Service
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
Check processed water tank and water
preparation; an on-going wash is complet-
ed using fresh water, the error must be quit
by pressing the emergency stop; an emer-
gency operation can be driven using fresh
water until the water preparation has been
repaired; call Customer Service
Check fresh water tank, check main water
pressure; repeat washing process, call
Customer Service
Check osmosis plant, call Customer Service
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
refill the corresponding detergent
Check water tank, repeat washing proc-
ess, call Customer Service
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
Repeat washing process, emergency op-
eration possible by using the second high
pressure pump, call Customer Service
Repeat washing process, emergency op-
eration with first high pressure pump is
possible, call Customer Service