Maintenance Schedule - Kärcher CB 1/23 Eco Bedienungsanleitung

Time Activity
daily Check safety installations Emergency-stop button on operating
Check notes for self-oper-
ation customers (only with
self-operation plants).
Check filling level of the
detergent.
Check spray jets for
blockage
Clean light barriers.
Visual inspection
Check brush rollers for
foreign bodies
Check water supply
weekly or Check condition of the
after 500 washing brushes.
washes
Check hoses and piping
for absence of leakness.
after 1000 Visual inspection
washes
Reset
28

Maintenance schedule

Assembly affected
point for manual mode, wash card/code
reader, all other emergency-stop but-
tons in the plant, safety switches in the
small halls.
Signs with operation instructions and
proper use according to the stipulations
to be placed at the wash place.
The detergent container is located in
the column on the right when facing the
direction of travel
Jets in the upper section, jet pipes on
the columns and the underfloor wash
plant (option)
All light barriers (diagrams 2 und 9)
All limit switches (see diagrams 3 to 6) Check for mechanical damage and stable
Side-brushes, roof brush, wheel brushes Make visible inspection, remove possible
Rinse and spray circulation
Roof brush roll and side brush rolls
Wheel washing brushes (option)
Hoses of the supply line and in the portal Visual inspection
Running rollers of the side-brushes'
wagon (Diag. 7)
Screws for guide rails (roof brush, drier) Check using a hexagon socket wrench that
EN
Remedy
Start wash programme, activate emergen-
cy-stop buttons or safety switches. The
plant must stop, then press the control sup-
ply voltage/normal position button on the
operating point for manual mode.
Check signs for completeness and legibility.
Replace damaged signs.
If necessary, fill up.
Make visible inspection (judge spray pic-
ture), if necessary, clean. Warning! Do not
mix up jets! Screw off jets individually, clean
with compressed air, screw on again.
Applying gentle pressure, wipe light barriers
with a detergent-free soft, damp cloth.
seating.
foreign bodies that are present, clean soiled
brushes with high-pressure cleaner.
Shut off water in manual operation and
check whether enough water is present in
the vehicle wash. Too little or no water may
cause damage to the vehicle being washed.
Check brush shaft for straightness, check
brush segments on firm seating, check
brush for wear (minimum bristle length: new
state minus 50 mm) if necessary, replace.
Replace brushes after approx. 10000 wash-
ing processes. For this: loosen 3 screws
within the bristle ring, remove wheel wash-
ing brush, attach new wheel washing brush
and fasten it with the 3 screws.
Check play by moving the side-brushes. In-
form Customer Service when there is too
much play between roller truck and guide:
screws are firmly screwed in, tighten if nec-
essary (apply approx. 25 Nm tightening
torque)
9
-
of whom
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator/
Custom-
er Service
Operator/
Custom-
er Service
Operator
Operator/
Custom-
er Service