Kärcher CB 1/23 Eco Bedienungsanleitung Seite 32

26 CAN bus error, module A23, no connec-
tion (gate control)
27 CAN bus error, module A24, no connec-
tion (gate control)
28 CAN bus error, module A25, no connec-
tion (washing phase display)
29 CAN bus error, module A26, no connec-
tion (Interface wash card reader in feed
distributor)
30 CAN bus error, module A27, no connec-
tion (high pressure pump)
31 CAN bus error, module A28, no connec-
tion (external dosing pumps)
32 Excess current outlets CAN Bus module
A10 (main plate)
35 Excess current outlets CAN Bus module
A14 (water distributor)
36 Excess current outlets CAN Bus module
A13 (feeder)
37 Excess current outlets CAN Bus module
A11 (in main switching cabinet CB1)
38 Excess current outlets CAN Bus module
A12 (in main switching cabinet CB1)
40 Excess current outlets CAN Bus module
A21 (anti-frost)
41 Excess current outlets CAN Bus module
A22 (underbody cleaning)
42 Excess current outlets CAN Bus module
A23 (gate control)
43 Excess current outlets CAN Bus module
A24 (gate control)
44 Excess current outlets CAN Bus module
A25 (washing phase display)
45 Excess current outlets CAN Bus module
A26 (Interface wash card reader in feed
distributor)
46 Excess current outlets CAN Bus module
A27 (high pressure pumps)
47 Excess current outlets CAN Bus module
A28 (external dosing pumps)
48 EE_prom not read
49 E_prom checksum error
50 Limit switch FA (drive start) has not been
exited despite driving command
51 Limit switch FA (Drive start) has not
reached expected position
52 Limit switch FE (drive end) has not been
exited despite driving command
53 Limit switch FE (Drive end) has not
reached expected position
32
Loose connecting chord of the plates,
plates defective
Short circuit, water leakage
Error in main plate
Limit switch activated through foreign met-
al or is defective
13
-
EN
Switch off and switch on the unit, repeat
washing process, call Customer Service
Switch off and switch on the unit, repeat
washing process, call Customer Service
Check limit switch portal driving for de-
fects; remove metal parts from the hall
floor; switch off/on the unit, repeat washing
process