Statistics - clage DSX Touch Gebrauchsanleitung Für Den Anwender

3. How to use
Quantity: Under "Quantity" tap on or to set the desired water quantity and then tap
on "START" to activate Automatic mode. The view changes to the main control where
the set quantity is displayed directly below the temperature display. Turning on the hot
water tap starts the function and the set fill quantity counts down in litre increments
according to the flow measurement.
Continued turning off and on of the tap pauses and restarts the function. If hot water is
already flowing whilst the function is activated, it starts immediately. To cancel the func-
tion, touch the fill quantity for three seconds or turn off the water flow for a minute.
When the fill quantity is reached, "0 l" flashes briefly on the display. A long acoustic
signal can also be heard and an instruction message appears on the display. The flow
quantity is reduced to approx. 3 l/min until the hot water flow is stopped or the message
is confirmed. This method ensures that any heated water continues to run and the bath
does not cool down. Flow noises can occur during the flow reduction.
Turning off the tap is always necessary, the function must therefore not be used unsuper-
vised.
Before using the bath, make sure that the water temperature is what you want it to be.
Hint: The water amount of the last draw-off is stored in the "Statistics" menu. To deter-
mine the necessary amount of water for your bathtub, fill it with warm water, then select
"Statistics" in the main menu and read out the value of this last drawing. Enter this value
in the automatic function "Quantity" to use it for the next bathtub filling.
Note: In the event of a power cut whilst the automatic is running according to the
fill quantity, the water flow is reduced to a minimum after the power has been
restored, a prompt appears on the display and an alarm signal can be heard until
the prompt is acknowledged by tapping on "OK".

Statistics

The statistics save the consumption and usage data for the appliance and display them
in graph format:
Water consumption
Power consumption
Total consumption costs
to scroll through the different periods. The consumptions are displayed
Tap on or
consecutively in diagrams over a period from the last drawing of water, the consump-
tion today, the consumption yesterday, over the last seven days, the last four weeks,
the last twelve months and the last four years.
The last overview shows, if the savings target is activated, when your savings target
was reached or exceeded in the last twelve months. Furthermore, it calculates how
much your energy and water consumption has stayed below the savings target, and
displays the figure.
Note: The consumption data are not suitable for billing purposes.
21
CLAGE
EN