Herunterladen Inhalt Inhalt Diese Seite drucken

Handling; Displayed Information - clage DSX Touch Gebrauchsanleitung Für Den Anwender

E-komfortdurchlauferhitzer
Vorschau ausblenden Andere Handbücher für DSX Touch:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4. Remote control
5. The display switches to the setpoint value display.
Note: For initial installation we basically recommend to change the radio channel.
In the case of an unsuccessful registration the display indicates "
radio signal after 45 seconds. The remote control quits the registration process and
switches to standby mode. By pressing a key the registration process will be repeated.
Notes:
• With no remote control registered or without working radio connection, the instan-
taneous water heater heats to the prior selected set temperature.
• For the professional: After a reset at the water heater (refer to installing instructions,
chapter "Reinstallation") a registration is required!

Handling

The remote control is equipped with the following functions:
1. Arrow buttons
You can set the required temperature gradually to a lower or higher value using the
arrow two buttons
and
.
Note: If the temperature display is set to " -- " with arrow button
neous water heater switches off the heating function.
2. Programme buttons
The two programme buttons
without the need to press the
The factory setting for programme
assign your own settings for the programme buttons:
• Select the desired temperature with
• To save the current temperature, press the programme button
seconds.

Displayed information

Energy saving mode
The symbol
shows that the appliance works in an energy saving mode, i.e. the
momentary energy consumption is subject to the selected temperature and to the flow
rate in the energy saving mode.
Power limit
If the full output of the instantaneous water heater does not suffice to heat the tapped
quantity of water, this will be indicated by
Operation with preheated water
If the cold water inlet temperature is higher than the set value of the hot water outlet,
the instantaneous water heater will not heat. In this case no power is emitted and the
sun symbol
is displayed.
27
and
allow to quickly select the preset temperature
and
buttons several times.
is 35 °C and for programme
and
.
on the LCD.
CLAGE
no
" by a flashing
EN
, the instanta-
it is 48 °C. You can
or
for about two

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis