Inhaltsverzeichnis
Werbung
EnDaL smart
P R O D U C T C E R T I F I C A T I O N
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
Modifications not expressly approved by this company could void the user's
This equipment has been tested and found to comply with the limits for a Class B, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
This device complies with Industry Canada's RSS-310. Operation is subject to the
condition that this device must not cause harmful interference and must accept any
interference, including interference that may cause undesired operation of the
Cet appareil est conforme à la norme RSS-310 d'Industrie Canada. L'opération est
soumise à la condition que ce dispositif ne doit pas causer d'interférence nuisible et
doit accepter toute interférence, y compris les interférences qui peuvent entraîner
Das Produkt entspricht bei bestimmungsgemäßer Verwendung den grundlegenden
This device has been designed to operate with the antennas listed below (see Technische Parameter). Antennas not
included in this list are strictly prohibited for use with this device. The required antenna impedance is 50
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.
Cet appareil a été conçu pour fonctionner avec les antennes énumérées ci-dessous (voir 2. Paramètres techniques). Les
antennes n'étant pas énumérées dans cette liste sont strictement interdites pour une utilisation en combinaison
Afin de réduire les interférences radio potentielles pour les autres utilisateurs, le type d'antenne doit être choisi afin que
la puissance isotrope équivalente (e.i.r.p.) ne soit pas supérieure à celle permise pour réaliser une
may cause undesired operation.
authority to operate the equipment.
the user will be required to correct the interference at his own expense.
un mauvais fonctionnement de l'appareil.
Anforderungen der folgenden EU-Richtlinien (www.monilog.de)
2014/53/EU (RED – Richtlinie)
2011/65/EU (RoHS Richtlinie)
2012/19/EU (WEEE – Richtlinie)
avec cet appareil. L'impédance de l'antenne requise est de 50 ohms.
communication stable.
- 1 -
PRODUCT CERTIFICATION
device.
ohms.
Werbung
Inhaltsverzeichnis
