tau K570M Installationsanleitung Seite 16

LEARNING SYSTEM FOR RADIO CONTROL DEVICES
P1 = OPEN/CLOSE
P2 = 2nd channel
1_ press button P1 briefly to associate a radio control device with the OPEN/CLOSE function;
2_ LED DL8 turns off to indicate that the code learning mode has been activated (if no code is
entered within 10 seconds, the board exits the programming mode);
3_ press the button of the relative radio control device;
4_ LED DL8 turns on again to indicate that the code has been memorised (if this does not hap-
pen, wait 10 seconds and start again from point 1);
5_ to memorise codes to other radio control devices, repeat the procedure from point 1 up to a
maximum of 8 transmitters;
6_ to memorise codes on the 2nd channel, repeat the procedure from point 1 using button P2
instead of P1;
7_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
Note: if the maximum number of radio control devices (8) is exceeded, LED DL8 flashes
rapidly for about 3 seconds without memorising the code.
REMOTE PROGRAMMING BY MEANS OF T-4RP, K-SLIM-RP AND BUG-R
With the new version of software V 2.xx it is possible to carry out the remote self-learning of
the new version of transmitters T-4RP, K-SLIM-RP and BUG-R, that is without pressing the re-
ceiver's programming button.
It will be sufficient to have an already programmed transmitter in the receiver in order to start
the procedure of remote programming of the new transmitters, programmed by means of TAU-
PROG. Follow the procedure written on the instructions of the transmitter T-4RP, K-SLIM-RP or
BUG-R.
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button P1 pressed for 3 seconds in order to cancel all the associated radio control
devices;
2_ LED DL8 flashes slowly to indicate that the cancellation mode has been activated;
3_ press button P1 again for 3 seconds;
4_ LED DL8 turns off for approx. 3 seconds and then remains steady to indicate that the code
has been cancelled;
5_ repeat the procedure from point 1 using button P2 to cancel all the associated radio control
devices;
6_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
ATTENTION: TO memorise a code on a new type of remote control unit (e.g.: from dip-
switch to rolling code or vice-versa) both channels must be cancelled.
MALFUNCTIONS: POSSIBLE CAUSES AND SOLUTION
The automation does not start
a- Check there is 230Vac power supply with the multimeter;
b- Check that the NC contacts of the card are actually normally closed;
c- Set dip 7 (phototest) to OFF;
d- Check that the fuses are intact with the multimeter.
The radio control has very little range
a- Connect the radio aerial to the terminals of the receiver card and not to terminals 16-17
of the control card;
b- Check that the ground and the aerial signal connections have not been inverted;
c- Do not make joints to increase the length of the aerial wire;
d- Do not install the aerial in a low position or behind walls or pillars;
e- Check the state of the radio control batteries.
The gate opens the wrong way
a_ Invert the position of dip-switch No. 10 after having turned off the power to the control unit.
16 K570M