Intended Use; Information In The Event Of An Emergency - Prominent Dulcotest Montage- Und Betriebsanleitung

Introduction
1.4

Intended use

NOTICE!
Intended use
– The sensor may only be used
to measure and regulate
inductive conductivity
– All other uses or modifications
are prohibited
– The sensor is not a safety
component in the sense of DIN
EN ISO 13849-1:2008-12. If
there is a critical process in
your measurement and control
circuit, then it is your responsi‐
bility to make sure this process
is safe
1.5 Information in the event of
an emergency
In the event of an emergency, switch
n
off the controller
If liquid escapes from the continuous
n
flow gauge, close the stopcocks on
the inlet and outlet installed by the
customer
Observe the plant operator's safety
n
information before opening the contin‐
uous flow gauge
46