Jackle conMIG 445 Betriebsanleitung Seite 35

6 EMC and safety inspection
Apart from the instructions given in this operating manual, the general safety standards, in particular the rules
for prevention of accidents must be observed. The rules contain additional information's about the prevention of
radiation, smoke, combustion, electric shock, fire and explosion.
Furthermore, we point out that in some operative ranges where, despite the observance of radiation limits, this
welding unit can cause electromagnetic interferences which are the responsibility of the user.
This means that in the domain of hospitals, for instance, the function of electro medical units, data-processing
equipment and the like (ECG, PC etc.) may be impaired.
Before putting the welding unit into service, please make sure to inform the authorities in charge of the above
mentioned equipment.
If you wish to use the cutting unit in domestic areas, special precautions have to be taken as well.
Adequate assistance in assessing the operative range and minimizing electromagnetic interferences (e.g. use of
screening lines) may be obtained from the Electromagnetic Compatibility Standards for Arc Welding Systems.
EN 60 974-10 (Electromagnetic compatibility EMC)
Safety inspection:
The owner/operator is obliged to have a safety inspection performed on the machine at least once every 12
months.
Observe the relevant national and international standards and directives in connection with the safety
inspection.
More detailed information on safety inspections and calibration is available from your regional or national
service centre, who will be pleased to provide you with copies of the necessary documents upon request
e.g.: EN 60974-4 (Safety, maintenance and inspection of arc welding equipment in use)
ATTENTION:
This device is not suitable for defrost tubes or similar non welding agitation's!!!
7 Disposal of the machine
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility. As the owner of the equipment, you should
get information on approved collection systems from your local representative.
For more information look in the web after the keyword ‚WEEE'.
Operating manual
conMIG 400/445/545
Page 32