Operation Procedure - Toshiba RBC-CR1-PE Benutzerhandbuch

Procedure
Supply power to Central Remote Controller
and the respective indoor unit.
To start the air conditioner press the MONITOR/SET
button.
Select the setting mode
a) SINGLE SELECT
b) SELECT ALL
Setting of the operation modes and fan speeds
are carried out by pressing the respective buttons.
To start the air conditioner press the ON button.
Select the restriction in use by pressing
SELECT CONTROL.
NO DISPLAY
CENTRAL
LOCKED
Press the MONITOR/SET button.
If the new settings are not registered by pressing the MONITOR/SET button within 15 seconds of the last change the
status of the Central Remote Controller will revert to the monitor mode without changing any settings.
To stop the air conditioner press the
MONITOR/SET button.
To select the air conditioner to be switched off press
the SINGLE SELECT button or press the
SELECT ALL button if you wish to stop every unit.
Press the OFF button.
Press the MONITOR/SET button.
GB
AI C R
ENTRAL EMOTE
O
PERATION
STARTING THE CONNECTED AIR CONDITIONERS
STOPPING CONNECTED AIR CONDITIONERS
– 7 –
C
ONTROLLER
P
ROCEDURE
Page Remarks
8 The display changes from monitor to set.
8
The operational conditions for one air
conditioner or group.
The operational conditions for every air condit-
ioner connected to the Central Remote Controller.
9 The settings can be verified by looking
at the LCD display.
8
11
11 Last touch priority.
In the Central mode, operation of the air
conditioner is restricted to ON/OFF operation.
In the Locked mode the air conditioner
remains in the OFF mode.
8 To register the changes the Central Remote
Controller will change to monitor. The
respective air conditioners will start.
8 The display changes from monitor to set.
8
8
8 To register the changes the Central Remote
Controller will change to monitor. The
respective air conditioners will stop.