Unit Setting Procedure - Toshiba RBC-CR1-PE Benutzerhandbuch

1 MONITOR/SET Button
Select the setting mode by pushing this button. SET
will begin to flash on the display.
2 SINGLE SELECT / SELECT ALL Buttons
Select the unit(s) whose settings require modifica-
tion by pressing these buttons.
3 MODE Button
Select the required mode by pressing this button.
FAN ONLY COOL
4 FAN Button
Select the required fan speed by pressing this
button.
AUTO HIGH MED
5 TEMP ADJUST Buttons
These keys are used to set the required room
temperatures (18-29 ˚C).
In the AUTO mode the fan speed changes
according to the room temperature.
If the operation of the air conditioner is stopped and immediately restarted by pressing the ON/OFF Button,
the air conditioner will not operate for 3 minutes to protect the unit. After the three minutes the unit will be
allowed to start.
Starting of the Heating operation
After the pre heat defrost operation that lasts for 3 to 5 minutes with the indoor fans stopped. The fans will
then operate at the set fan speed.
Starting of the Cooling operation
The air conditioner will start in the cooling mode after approximately 1 minute.
AI C
ENTRAL
U S
NIT ETTING
HEAT AUTO
LOW
GB
R C
EMOTE ONTROLLER
P
ROCEDURE
6 LOUVER Button
If the unit has a motor driven louver it can be
switched on and LOUVER will be displayed.
7 ON/OFF Button
When this key is pressed the selected air
conditioner will be switched on or off when the set
button is pressed.
8 To register changes to the operating conditions
of the air conditioners press the MONITOR/SET
Button.
The display changes from set to monitor.
– 9 –