Toshiba RBC-CR1-PE Benutzerhandbuch Seite 6

C
ENTRAL
1 MONITOR/SET Button
This is used to select the monitoring or setting modes
for the Central Remote Controller.
2 SINGLE SELECT Button
This is used to individually select an indoor unit
connected to the Central Remote Controller.
3 SELECT ALL Button
This is used to set same operating conditions for all
of the connected indoor units.
4 ON/OFF Buttons
These buttons are used to turn the air conditioners
on or off.
5 SELECT CONTROL Button
This is used to supervise different levels of
operation at the Standard Remote Controller.
6 MODE Button
Selects the desired operation mode, each time it is
pressed the display changes in the following
sequence:-
FAN ONLY COOL
7 FAN Button
Selects the desired fan speed mode, each time it is
pressed the display changes in the following
sequence:-
AUTO HIGH MED
AI C
ENTRAL
R C
EMOTE ONTROLLER
HEAT AUTO
LOW
GB
R C
EMOTE ONTROLLER
B
UTTON
8 LOUVER Button
This is used to drive the outlet louvers automati-
cally when the air conditioner is in operation. When
it is pressed the louvers will start oscillation and
LOUVER will be displayed, when it is pressed again
the louvers will stop. If no automatic louvers are
fitted and this button is pressed then LOUVER
MANUAL is displayed.
9 TEMP ADJUST Buttons
These buttons are used to set the required room
temperatures (18-29 ˚C).
10 TIMER Button
This button is used to enable operation with a
7 Day Timer.
11 CHECK Button
Displays fault codes for the use of the Service
Engineer.
12 FILTER Button
This button is used to reset the filter display.
00
– 6 –
O
PERATIONS