Technical Specifications - Siemens 7KG6106 Betriebsanleitung

QUALIFIED PERSONNEL
If this appliance is interfered with by unqualified persons or if the safety warnings in this
manual are not heeded, then severe injury or damage may result. Therefore, only suitably
qualified personnel may service this appliance. Qualified personnel, in the sense of the
safety instructions in this handbook or on the product itself, are such persons who, as project
personnel, are well acquainted with safety concepts in automation engineering;
• as operating personnel, have been trained in the use of such equipment and are
conversant with the sections of this manual dealing with operation;
• as service and maintenance personnel, have attended training on the repair of
automation equipment
• or have the authorization to set-up, earth, and identify circuits and
appliances/systems according to the relevant safety standards.

2.7 Technical Specifications

Input
max. nominal voltage
power consumption
premissible control range
nominal frequency f
frequency range f
curve forms
peak factor
Input transducer alternating
current
standard nominal current I
measuring range at nominal value I
continuous overload
surge overload capability
for I =  A; . A; .5 A;
EN
 A; .4 A; .5 A
for I = 5 A; 6
EN
EN
E
EN
EN
A; 7.5 A; 0 A
SIMEAS-T - Transducer with Auxiliary Power
Only for connection to AC systems
Y 30 / 400 V und 500 V
ca. 0,06 VA
, I or , U
EN EN
50 Hz, 60 Hz
45 Hz bis 65 Hz
sine, rectangular, triangular, phase approach
i/I ≤ 2, but I ≤ 2,1 I
rms EN
U/U E ≤ 2, but ≤ 2,1 I
EN EN
I
E
see ordering table
0 to I
EN
 I
EN
00 A for s
00 A for s
9