Before First Use - Silvercrest SDBR 420 A1 Bedienungsanleitung

Before first use

1) Remove the iron from the packaging .
2) Remove all stickers and protective films from the iron and from the
sole of the iron 8 .
RISK OF SUFFOCATION!
► Plastic bags may pose a risk . To avoid the risk of asphyxia-
tion, keep plastic bags out of the reach of toddlers and small
children .
3) Open the water tank filler opening 1 and fill the water tank with
water (See the section Filling the water tank) .
4) Set the correct voltage using the voltage switch 7 . You can, for
example, use a thin pin or a straightened paper clip to do this .
― Slide the voltage switch 7 to the right to set a voltage of
220–240 V (e .g . for Europe/Switzerland) .
― Slide the voltage switch 7 to the left to set a voltage of
100–127 V (e .g . for USA/Japan) .
5) Insert the plug into a mains power socket supplying the voltage
you have set .
6) Set the temperature control 4 to "MAX"
7) Heat the iron up for several minutes at the highest setting .
8) If clicked in: press the steam switch
and protrudes beyond the appliance surface . Steam will
come out of the sole of the iron 8 continuously if you hold
the iron horizontally .
SDBR 420 A1
.
3 so that it releases
GB │ IE │ NI │ CY │ 11 ■