Faults - Kärcher BR 40/25 C Ep Betriebsanleitung

Danger
Risk of injury. Turn the program selection
switch to "OFF" and disconnect the mains
plug before performing any works on the
appliance.
Fault
Appliance cannot be
started
Insufficient water quan-
tity
Insufficient vacuum per-
formance
Insufficient cleaning re-
sult
Brushes do not turn
22

Faults

Remedy
Check if the mains plug is connected.
Check fresh water level, refill tank if necessary.
Check hoses for blockages; clean if required.
Check the condition of the seals between dirt water reservoir and
cover, replace if required.
Clean the fluff filter
Clean the vacuum lips on the vacuum bar, turn or replace if re-
quired
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Check the brushes for wear, replace if required.
Check if foreign matters block the brushes; remove foreign matter
if required.
 Place the appliance on an even sur-
face.
 Drain and dispose of the dirt water and
the residual fresh water.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Faults
– 9
EN