Kärcher BR 40/25 C Ep Betriebsanleitung Seite 19

Setting the advance speed (BD
model only)
 Turn the running gear to the front with
your foot.
 Reducing the speed: Turn the wheel in
– direction.
 Increasing the speed: Turn the wheel in
+ direction.
Establish mains contact
 Insert the looped end of the extension
cable in the strain relief hook.
 Plug in the mains plug.
Cleaning
 Turn the running gear to the back with
your foot.
 Turn the program selection switch to
the desired cleaning program.
 Set the water quantity according to the
degree of dirt accumulation and the
floor covering.
 Lower the vacuum bar.
 Turn on the brushes by pulling the con-
trol handle.
Caution
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Shutting Down the Appliance
 Close the water quantity regulator.
 Drive the appliance forward for another
1-2 m to draw off residual water.
 Turn the program selection switch to
"OFF".
 Raise the vacuum bar.
 Turn the running gear to the front with
your foot.
Caution
Danger of deformation of the brush(es).
When shutting down the appliance relieve
the brush(es) by turning forward the run-
ning gear.
Emptying the Dirt Water Reservoir
Note
If the dirt water reservoir is full the float
closes the suction channel. The suction op-
eration is interrupted. Empty the dirt water
reservoir.
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
 Take the dirt water discharge hose from
the support and lower above a suited
collection device.
 Let off water by opening the dosage de-
vice at the discharge hose.
 The rinse the dirt water reservoir with
clear water.
– 6
EN 19