Maintenance And Service - AL-KO SOLO Series Betriebsanleitung

Checking by a qualified service agent is
necessary:
- after impact with an obstacle
- if the V-belt is defective
- if the engine comes to an immediate standstill
- if the brake performance drops
- if the blade is bent (do not straighten)
- if the drive belt slips
- if the blade shaft is bent (do not straighten)
- if there is a defect in the blade holder
- if there is damage to the transmission.

MAINTENANCE AND SERVICE

Maintenance, service and cleaning work may only be carried out when the machine has been turned off and has cooled down
and the ignition key has been removed.
The following tasks may be carried out by the user himself. All the other maintenance, service and upkeep tasks must be carried
out by a qualified service agent.
Check level of engine oil
Change engine oil
Clean the air filter
Replace the air filter
Check the spark plug
Check the brake
Check the tyre pressure
Check mowing blade
Check for loose parts
Check drive belt
Clean the lawn tractor
Clean air intake grille on engine
Clean grass and cuttings from transmission
For hydrostat drive:
Clean ventilator for transmission cooling
Lubrication plan page GB 14
In cases of high load and high temperatures, shorter maintenance intervals than those stated in the table may be necessary.
GB
Before each
After each use
use
GB13
After 25 hours
After the first 5
of operation
hours
)* see operating instructions of the engine manufacturer
After 50 hours Before each
of operation storage