Operating Elements; Light Switch; Ignition Lock - AL-KO SOLO Series Betriebsanleitung

OPERATING ELEMENTS

Gas lever
8
The engine speed is regulated with the gas lever. In order to
mow as effectively as possible, the gas lever should be swit-
ched to

Light switch

Use the light switch to switch the headlights on.
(Configuration varies and depends on model)

Ignition lock

To start the engine, put the ignition key into the ignition lock
and turn to the right to position "II".
As soon as the engine is running, let go of the ignition key
(ignition key returns to position "I").
To switch the engine off, put the gas lever onto
then turn the ignition key onto position "0".
11
Mowing appliance switch
The mowing appliance is operated with this toggle switch.
Switch position
Switch position
9 Meaning of the symbols on the pedal
Clutch
Brake
.
- mowing appliance switched on
- mowing appliance switched off
GB
9
"Clutch / Brake" pedal
If the pedal is half pushed down, the clutch is disenga-
ged. If the pedal is completely pushed down, the clutch
is disengaged and the disk brake of the transmission
operated.
With the pedal completely pressed down, the pedal can
be locked in the "Brake" function by pushing the stop
lever to the left (with the heel of the shoe).
Pushing the pedal down again cancels the locking - the stop
lever returns to the original position.
Foot pedals (for hydrostat drive)
10
Possible transmission positions:
Forward gear: - infinitely adjustable,
Reverse gear: - infinitely adjustable
and an automatic position.
,
Position lever for adjustment of cutting
11
height
The mowing appliance is lifted or lowered with the position
lever.
Six positions are available. In order to get from a higher to a
lower position, the push button on the end of the lever must
be pushed to unlock it.
In order to reach a higher position, simply push the lever
upwards into the required position
GB10