Preparation; Power Sources; Using A Aaa Battery; Power Supply Status Indicator - Tascam DR-10SG Bedienungsanleitung

Preparation

Power sources

This unit can operate on one AAA battery or USB bus
power using a USB cable.
This unit can use an alkaline, Ni-MH or lithium AAA
battery.

Using a AAA battery

Open the battery compartment cover on the back
of the unit. Install 1 AAA battery in the compartment
with the ¥ and ^ marks as shown. Then, close the
battery compartment cover.
When using a AAA battery, set the type of battery
in order to accurately show the amount of power
remaining and allow the unit to accurately
determine whether power is available for proper
operation. (See "Making menu settings" on page
13.)
CAUTION
• AAA manganese dry cell batteries cannot be
used with this unit.
10
TASCAM DR-10SG
• This unit cannot recharge AAA Ni-MH batteries.
Use a commercially-available recharger.

Power supply status indicator

When operating on battery power, a battery icon
appears at the top right of the display.
The battery icon shows the amount of power
remaining in bars ( q q ).
The battery is almost dead and the power will soon
turn off if the icon with no bars and the REC
indicator blink.
When operating on USB bus power, the icon
appears.

Using the cable clip

Attach the included cable clip to the cord holder on
the unit, and place the cable in it.
Cable clip use example

Using the noise isolation arm

By using the included noise isolation arm to attach
the mic, you can reduce the recording of camera
motor noise from autofocus, automatic image
stabilization and other operations.
Cable clip
Cable clip
Noise isolation arm