Left Side; Right Side; Bottom; Noise Isolation Arm - Tascam DR-10SG Bedienungsanleitung

i Unlit: The recording level is too low.
i Lit yellow: The recording level is low.
i Lit green: The recording level is good.
i Lit red: The recording level is too high.
e Locknut for attachment foot

Left side

r Cord holder
t USB port
This is a Micro-B USB port. Use a cable that
complies with USB standards to connect the
unit to a computer.
When connected, the
POWER/STORAGE
screen appears to allow selection of bus power
supply or data transmission by USB with the
computer.
CAUTION
The unit should be connected directly to the
computer, not through a USB hub.
/ jack
y
This is a combined headphone/line out jack.
Use the included attenuator cable to connect
this to a camera input.
u microSD card slot
Insert and remove microSD cards here.
Open the microSD card slot cover on the left
side. (See "Installing a microSD card" on page
11.)

Right side

i ¤ button
Press and hold the ¤ button for about one
second to turn the unit on/off.
NOTE
A one-second delay in response to this
operation occurs in order to prevent accidental
operation.

Bottom

o Attachment foot
p Tripod mounting threads (1/4-inch)

Noise isolation arm

a Cord holder
s Locknut for attachment foot
d Attachment foot
f Tripod mounting threads (1/4-inch)
CAUTION
• Never lift the connected device by holding this
unit or the noise isolation arm. Application of
excessive load could damage this unit or the
connected device.
• When not in use, disconnect this unit from the
connected device and store it. Application of
excessive load while connected could damage
to this unit or the connected device.
TASCAM DR-10SG
9