Operation; Switch Cabin Light On/Off; Adjusting The Clock And Water-Hardness Settings; Standby Mode On/Off - Villeroy & Boch Comfort Control Bedienungsanleitung

Comfort Control
5.

Operation

5.1.

Switch cabin light ON/OFF

1. Press button .
.
The cabin light goes on, and the corresponding symbol is displayed.
The cabin light can also be switched on when the master switch is off (e.g. for cleaning
the cabin).
5.2.

Adjusting the clock and water-hardness settings

Set clock time
1. Activate the control system at the master switch.
2. Press the MODE button.
.
The menu bar will be displayed.
3. Use the left/right buttons
.
The time and service symbol will be displayed flashing.
4. Set the time with the up/down buttons
. Each press of the button changes the time by one minute. Keep the button pressed to change the
setting at high speed.
5. Press the button
.
The time display will stop flashing.
6. Keep the MODE button pressed until END is displayed.
Adjusting the water-hardness setting
7. Disconnect the control system at the master switch.
8. Keep the button
. The water-hardness adjustment function will be displayed.
9. Set the water hardness with the up/down buttons
.
Possible settings range from 0 to 30 °dH. Ask your water utility for details of water hardness.
10. Press the button
. The display stops flashing. The control system goes into standby mode. The screen displays the
time.
5.3.

Standby mode ON/OFF

1. Actuate the master switch.
. When the master switch is ON, the control system is in standby mode and can be operated from
the control panel. The time is displayed.
Master switch
50701117/10.05
to select the menu symbol
.
to confirm the setting.
pressed while switching the master switch on.
to confirm the setting.
.
.
Control panel
PAGE 31