Exit Program - Villeroy & Boch Comfort Control Bedienungsanleitung

5. Operation
5.8.

Exit program

You can exit sauna or preselection mode while the program is running.
1. The control system exits the program automatically on expiry of the session time,
or
2. To exit the sauna program early, press the MODE button until END is displayed.
. The selected program ends automatically three seconds after the last button is pushed. The
control system goes automatically into standby mode. The time is displayed.
3. For reasons of hygiene, when the Comfort Climate/Infraclima session is over, drain off any unused
water still remaining in the water tank and vaporizer system.
' See section 5.10. - Shut down the vaporizer.
The most recently-used sauna program is saved when you exit the program.
When you press the MODE button to call up the sauna programs, the control system
starts by displaying the last program to be used.
Automatic post-program after Comfort Climate/Infraclima operation
. If Comfort Climate/Infraclima mode has been in use for longer than ten minutes, the post-program
function starts automatically when the program ends. This cause the "hairdryer" symbol
displayed. The time remaining until activation of the post-program function appears in the right
hand digital display, together with the "hourglass" symbol .
. The radiant heating system warms up once more, increasing the rate of air ventilation. This measure
is used to ventilate the cabin.
.
On expiry of the post-program function, the control system automatically switches to standby
mode. The time is displayed.
Ventilate the cabin after running the post-program function
D
Open the cabin door briefly after the post-program function ends.
PAGE 34
Comfort Control
to be
50701117/10.05