Preset Functions And Operations; List Of Preset Functions - Denon DN-C630 Bedienungsanleitung

ENGLISH
7

PRESET FUNCTIONS AND OPERATIONS

(1) List of Preset Functions

• Functions can be preset using the buttons on the front panel. These presettings are stored in a permanent memory, so they are
not cleared even when the power is turned off.
• The functions shown on the table below can be preset. Set the functions according to the usage purpose to efficiently achieve
even higher quality playback.
• One of the preset functions can be used to display information on this set (microprocessor version).
Preset function type
Preset type
Finish mode
Power on mode
Auto cue
Auto stop
Program 1
Program 2
Program 3
Digital output
End monitor
E.O.M.
Next track standby
Next Track Reserve
Fade in time
Play speed
Delay start
Play lock
Frame display
CDR disc
Parallel remote
Parallel remote
Parallel remote
Parallel remote
Stereo/Mono
Preset clear
Set information
When presettings are made, the time display set with the TIME button and the play mode set with the PLAY MODE button at that
time are stored in the memory. These modes will be set when the power is next turned on.
NOTE:
For CDR discs without TOCs, there are no pits (signals) at the disc's lead in and lead out sections, so errors may occur, particularly
when searching for tracks. If an error should occur, open the disc holder, then close it and perform the operation again.
20
Description
Selection of preset type.
Setting of operation when playback ends.
Setting of operation when power is turned on.
Setting of whether or not to perform the auto cue operation and the
audio startup level.
Setting of whether or not to automatically stop the servo functions.
Setting of whether or not to play program 1.
Setting of whether or not to play program 2.
Setting of whether or not to play program 3.
Selection of whether or not to output subcodes.
Setting of whether or not to use the end monitor function and monitor
time setting.
Setting of whether or not to display the EOM and display time setting.
Setting of whether or not to standby at the next track when the CUE
button is pressed during playback.
Setting of operation when select knob is turned during playback.
Fade in time setting.
Standard playing speed setting.
Delay start time setting.
Selection of whether or not to inhibit the panel switches during playback.
Selection of whether or not to display frames.
Selection of whether or not to test play CDR discs which do not include a
TOC.
Selection of whether or not to accept parallel remote signals.
Selection of whether or not to output standby tally.
External control tally output signal setting.
Fader start mode selection.
Selection of stereo or monaural playback.
Setting for clearing presets and setting them to the initial values.
Microprocessor version display.
Character display
(as set upon shipment No.
from factory)
Preset Type 1
Finish Next
Power On Stby
CueDet. –60 dB
Sleep ON
Program 1 OFF
Program 2 OFF
Program 3 OFF
Subcode OFF
End Mon. 10 s 10
E.O.M. 10 s 11
Next Stb. OFF 12
Reserve. OFF 13
FadeIn OFF 14
Normal Speed 15
Delay OFF 16
Play Lock OFF 17
FR Disp ON 18
Normal Disc 19
Remote ENA 20
ST. Tally ON 21
INDEX 2 Tally 22
Fader Pause 23
Stereo 24
Ini. Preset 25
Ver. **** (* = number) 26
1
2
3
4
5
6
7
8
9