Working With The Blender - Silvercrest KH 700 Bedienungsanleitung

• Place the lid 0 on the bowl
9 and the pusher w in the
filling shaft q.
• Set the speed controller 7 to the level recom-
mended in the table.
Hints:
• Put liquid ingredients into the bowl 9 last and
start mixing at low speed to avoid splashing.
• Never fill the mixing bowl 9 above the
MAX.mark (1.5l).
• For mixing "water like" liquids only use the speed
1 with maximum volume of 1 l to avoid liquid
spilling out.

8. Working with the blender

Caution:
• Never switch on the blender when empty.
• Never insert the plug in the socket before the
blender jug 4 and the blender lid 2 have been
correctly assembled.
• Always pull the plug from the socket before
removing the blender jug 4.
• Do not fill ingredients hotter than 80°C in the
blender jug 4.
• To avoid splashing, never add more than 1.5l of
liquid in the blender jug 4.
• Never remove the blender lid 2 during opera-
tion.
• Never run the blender continuously for more than
3 minutes.
You can use the blender to finely puree and mix in-
gredients. You can use the blender for preparing
soups, sauces, milkshakes, baby food or process ve-
getables and fruit into a puree
• Fill the ingredients in the blender jug 4. Cut them
into smaller pieces beforehand if required.
• Switch on the blender by setting the speed
controller 7 to the desired level.
- 7 -
• First remove the cover 5 for
the motor block 6 by turning
it clockwise.
• Now place the liquidiser 4 in
the opening, so that the arrow
marking on the liquidiser 4 po-
ints towards the open lock on
the motor block 6. Turn the li-
quidiser 4 anti-clockwise until it
is firmly seated. Ensure that the
arrow marking is pointing to-
wards the closed lock.
• Place the cover 2 on the li-
quidiser 4 so that the arrows
on the handle of the liquidiser
4 and on the cover 2 point
towards each other. Turn the
cover 2 anti-clockwise until it
sits firmly.
• If required, insert the splash
protection cap 1 and turn it
anti-clockwise to secure.