IKEA SMAKSAK Bedienungsanleitung Seite 17

ENGLISH
The display shows the symbol of the core
temperature sensor
core temperature.
4. Press to save the new core
temperature, or wait 10 seconds for the
setting to be saved automatically.
The new default core temperature is
displayed during the next use of the core
temperature sensor.
When the meat is at the set core
temperature, the symbol for the core
temperature sensor
core temperature flash. A signal sounds for
two minutes. The oven turns off
automatically.
5. Press any button or open the oven door
to stop the signal.
6. Remove the plug of the core
temperature sensor from the socket.
Remove the meat from the oven.
Warning! Be careful when you
remove the tip and plug of the
core temperature sensor. The
core temperature sensor is hot.
There is a risk of burns.
The Duration
not operate with the core
temperature sensor.
You can change the core temperature at
any time during the cooking:
1. Press :
• one time - the display shows the set
core temperature which changes
every 5 seconds to the current core
temperature.
• two times - the display shows the
current oven temperature which
and the default
and the default
and End do
changes every 5 seconds to the set
oven temperature.
• three times - the display shows the
set oven temperature.
2. Use the control knob to change the
temperature.
Using the telescopic runners
Keep the installation instructions
for the telescopic runners for
future use.
With telescopic runners you can put in and
remove wire shelves and trays easily.
Caution! Do not clean the
telescopic runners in the
dishwasher. Do not lubricate the
telescopic runners.
1
°C
Pull out the right
and left hand
telescopic runners.
Make sure you push back the telescopic
runners fully in the oven before you close
the oven door.
Warning! Refer to "Product
description" chapter.
17
2
°C
Put the wire shelf on
the telescopic
runners and
carefully push them
into the oven.