Flexible Shaft; Stand For The Multi-Tool - Parkside PFBS 160 B2 Originalbetriebsanleitung

■ Note that the maximum diameter of the grind-
ing assembly and of grinding cones, pencil
grinders and grinding points with a thread insert
may not exceed 55 mm and the maximum
diameter for sandpaper sanding accessories
may not exceed 80 mm.
NOTE
► The max. permissible length of a mandrel is
33 mm.
■ Store the accessories in the original box or store
the accessory components somewhere else to
protect them from damage.
■ Store the accessories somewhere dry and not in
the vicinity of aggressive media.
■ If you exert too much pressure, the fitted tool
can break and/or the workpiece could be dam-
aged. You will achieve optimum working results
by moving the tool over the workpiece at a
steady speed and while exerting light pressure.
■ When carrying out cutting work, hold the appli-
ance firmly with both hands.
■ Observe the data and the information in the ta-
ble to prevent the end of the spindle from touch-
ing the perforated base of the grinding tool.

Flexible shaft

■ Never operate the spindle lock while the motor
is running. Otherwise, the appliance or the flex-
ible shaft may be damaged.
♦ Screw the union nut
appliance and store it carefully.
♦ Press the spindle lock
♦ Screw the tensioning nut
the appliance.
♦ Fit the flexible shaft
do this, the internal access of the flexible shaft
push the tensioning nut
, .
♦ First tighten the tensioning nut
union nut of the flexible shaft
14b
onto the appliance with the combination span-
ner .
PFBS 160 B2
anticlockwise off the
and hold it down.
anticlockwise off
onto the appliance. To
into the collet chuck
and then the
clockwise
♦ Place the desired accessory into the collet
chuck , of the flexible shaft.
♦ Push the black the collar back onto the flexible
shaft to lock the spindle.
♦ Open the collet chuck mount
shaft with the combination spanner
attachment and screw the collet chuck mount
back in place.

Stand for the multi-tool

♦ Screw the stand
NOTE
► Depending on the desired attachment onto a
vertical or horizontal surface, you can screw
the stand into the clamping device in two
different positions.
♦ Screw the clamping device
a work bench or table with a maximum thick-
ness of 55 mm.
♦ The stand is height-adjustable. Undo the
upper part of the stand
clockwise (−). Pull out the tube to the maximum
height and lock it again by turning it clockwise
(+).
♦ The mount is also height-adjustable; turn
the black thread anticlockwise. After you have
set the mount to the correct height, tighten the
thread by turning in the opposite direction.
♦ Fix the appliance with the metal clip
mount of the stand
turned 360°.
on the flexible
. Fit the
into the clamping device
onto the edge of
by turning it anti-
onto the
. The mount can be
GB │ CY │
13
.
■