Flexible Shaft; Stretch Stand For The Multi-Function Tool; Base Assembly - Parkside PFBS 160 A1 Bedienungs- Und Sicherheitshinweise

Start-up
Function
Cleaning
Grinding
Cutting

Flexible shaft

Never use the spindle lock with the motor on.
The tool or the flexible shaft could otherwise
be damaged.
Unscrew the union nut
counter-clockwise, and put aside.
Press and hold the spindle lock
Unscrew the clamping nut
turning counter-clockwise.
Attach the flexible shaft
the inner axle on the flexible shaft along with
the clamping nut
Use the combination wrench
clamping nut
flexible shaft
Now insert the accessory you wish to use into
the collet
To lock the spindle, slide back the black sleeve
on the flexible shaft.
Using the combination wrench
collet holder
accessory and tighten the collet holder
Stretch stand for the multi-func-
tion tool (Fig. I)
Screw the stretch stand
Note: The stretch stand
into the clamp in two different positions, de-
pending on the whether you're attaching to a
horizontal or vertical surface.
14 GB
Downloaded from www.Manualslib.com
Accessory
Plastic brushes
30
Metal brush
31
Grinding discs
21
Grinding stone
Grinding bits
20
Sanding belts
24
Cutting discs
18
from the tool, turning
5
.
8
from the tool,
6
to the tool, inserting
13
into the collet
6 7
to first tighten the
33
, then the union nut
6
to the tool, turning clockwise.
13
of the flexible shaft.
7
, open the
33
on the flexible shaft, insert the
14
into the clamp
16
can be screwed
16
manuals search engine
Application
e.g. cleaning hard to reach plastic housings or
cleaning the area around a door lock
e.g. rust removal (see Fig. E)
(The metal brush is softer than steel)
Grinding stone, detail work on hard materials such
, as ceramics or alloy steel (see Fig. G)
23
Sanding wood
, Processing metal, stone (see Fig. H)
19
Secure the clamp
bench or a work table no thicker than 55 mm.
The stretch stand
the upper tube of the stretch stand
to the left (–). Extend the tube to the maximum
height and secure by turning to the right (+).
The holder
turn the black thread to the left. After adjusting
the holder to the correct height, turn the thread
in the opposite direction to tighten.
Secure the tool to the holder
stand
16
. er rotates by 360°.
15
of the
13 b

Base assembly

Using the attachment, the tool is particularly suited
for cutting special shapes (holes for sockets, etc.).
Attach the milling bit
„Attaching / changing the tool / collet".
Ensure that the bit's shaft protrudes from collet
. by approx. 13 mm.
14
Unscrew the union nut
clockwise, and put aside.
Screw the base
To set the correct working depth, loosen the
locking screw
. base assembly to the desired size.
17
Then tighten the locking screw
at the edge of a work-
17
is height adjustable. Loosen
16
16
is also height adjustable, simple
15
of the stretch
15
with the metal bracket
3
as described in chapter
27
from the tool, turning
5
onto the unit.
12
and adjust the bottom of the
11
.
11
by turning
. This hold-