Tips And Tricks; Flexible Shaft; Stretch Stand For The Multi-Function Tool; Base Assembly - Parkside PFBS 160 A1 Bedienungs- Und Sicherheitshinweise

Store accessories inside the original box or oth-
erwise protect the accessories from damage.
Store accessories dry and away from aggres-
sive media.

Tips and tricks

Applying excessive pressure can cause the in-
stalled tool to break and / or damage the work
piece. Optimal results can be achieved by ap-
plying the tool to the work piece at a steady
speed range and little pressure.
Hold the device with both hands whilst cutting.
Please note the data and information in the
chart to prevent the spindle end touching the
perforated plate of the grinding tool.

Flexible shaft

Never use the spindle lock with the motor on.
The tool or the flexible shaft could otherwise
be damaged.
Unscrew the union nut
counter-clockwise, and put aside.
Press and hold the spindle lock
Unscrew the clamping nut
turning counter-clockwise.
Attach the flexible shaft
the inner axle on the flexible shaft along with
the clamping nut into the collet
6
Use the combination wrench
clamping nut , then the union nut
6
flexible shaft to the tool, turning clockwise.
14
Now insert the accessory you wish to use into
the collet , of the flexible shaft.
7 26
To lock the spindle, slide back the black sleeve
on the flexible shaft.
Using the combination wrench
collet holder on the flexible shaft, insert the
15
accessory and tighten the collet holder
from the tool, turning
5
.
9
from the tool,
6
to the tool, inserting
14
, .
7 26
to first tighten the
25
of the
14 b
, open the
25
.
15
Stretch stand for the
multi-function tool (Fig. J)
Screw the stretch stand
Note: The stretch stand
into the clamp in two different positions, de-
pending on the whether you're attaching to a
horizontal or vertical surface.
Secure the clamp
18
bench or a work table no thicker than 55 mm.
The stretch stand
17
the upper tube of the stretch stand
to the left (–). Extend the tube to the maximum
height and secure by turning to the right (+).
The holder is also height adjustable, simple
16
turn the black thread to the left. After adjusting
the holder to the correct height, turn the thread
in the opposite direction to tighten.
Secure the tool to the holder
stand with the metal bracket
17
er rotates by 360°.
16

Base assembly

Using the attachment, the tool is particularly suited
for cutting special shapes (holes for sockets, etc.).
Attach the milling bit
„Attaching / changing the tool / collet".
Ensure that the bit's shaft protrudes from collet
by approx. 13 mm.
Unscrew the union nut
clockwise, and put aside.
Screw the base
13
To set the correct working depth, loosen the
locking screw and adjust the bottom of the
12
base assembly to the desired size.
Then tighten the locking screw
Start-up
into the clamp
17 18
can be screwed
17
at the edge of a work-
is height adjustable. Loosen
by turning
17
of the stretch
16
. This hold-
3
as described in chapter
31
from the tool, turning
5
onto the unit.
.
12
GB
.
47