Vacuum Dust Extraction; Dust Box For Internal Vacuum Extraction; Reducer Piece; Attaching / Detaching Sanding Sheets - Parkside PHS 160 A1 Bedienungs- Und Sicherheitshinweise

Preparing for use
©

Vacuum dust extraction

WARNING!
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the
vacuum's dust bag) may ignite, e.g. as a result of
flying sparks generated when abrading metals or
metal objects left in wood. This can happen partic-
ularly if the wood dust is mixed with paint residue
or other chemicals and the abraded particles are
hot from prolonged abrasion. Therefore you must
empty the device's dust collection box and the
vacuum cleaner's dust bag before taking a break
or stopping work and always avoid overheating of
the abraded particles and the device.
Wear a dust mask!
WARNING!
out of the socket before doing any work on the
device.
©
Dust box for internal
vacuum extraction
Connection:
Push the dust box for internal vacuum extraction
on to the hand-held sander until it engages.
4
Removal:
Press the release button
box for internal vacuum extraction
withdraw it towards the rear of the device.
©

Reducer piece

Connection:
Push the reducer piece
port .
2
Push the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the reducer piece
10 GB
Downloaded from www.Manualslib.com
DANGER OF FIRE! There is
Always pull the mains plug is
of the dust extraction
5
4
into the adapter
3
manuals search engine
Removal:
Pull the dust extraction device hose off the
reducer piece
Pull off the reducer piece
©
Attaching / detaching
sanding sheets
WARNING!
of the socket before doing any work on the device.
Attaching:
Sanding sheets are attached to the backing plate
7 by means of the hook and pile fastening.
Detaching:
Simply pull the sanding sheet off the backing
plate
7
©

Rotating the backing plate

WARNING!
of the socket before doing any work on the device.
Rotate the backing plate
position (see Fig. D).
Sanding and surfaces:
The sanding output and the quality of the surface
finish are determined by the grade of grit on the
sanding sheet.
Always use sanding sheets with grades that
are suitable for the particular surface you are
sanding.
and
©

Advice on use

Switch the device on before placing it against
the workpiece.
Apply light sanding pressure only.
Advance the device at an even rate.
Change sanding sheets at the appropriate time.
Do not work on different types of material using
the same sanding sheet (e.g. wood and then
metal). To achieve the best sanding results you
. should use unworn, undamaged sanding sheets.
3
.
3
.
3
Always pull the mains plug is out
(see Fig. C).
Always pull the mains plug is out
into the desired
7