Operation - Kärcher NT 30/1 Tact Te M Bedienungsanleitung

Wet vacuum cleaning
DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Close the suction connection
Illustration
 Precisely fit the plug into the suction
connection.
 Insert the plug up to the stop.
Remove the fleece filter bag
Illustration
 Release and remove the suction head.
 Pull out the fleece filter bag on the
flange towards the top.
 Tightly close the fleece filter bag with
lock cap.
 Dispose of the fleece filter bag accord-
ing to the local provisions.
 Insert and lock the suction head.
– To suck wet dirt, first remove the fleece
filter bag.
Removing the dust disposal bag
Illustration
 Release and remove the suction head.
 Put the disposal bag over.
 Tightly close the disposal bag with ca-
ble tie underneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according
to the local provisions.
 Insert and lock the suction head.
– To suck wet dirt, always remove the dis-
posal bag.
Drain off dirt water
NT 50/1 only:
Illustration
 Drain off dirty water through the drain-
age hose.
20
General
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All accessories with a nominal
width of 35 mm can be connected.
Appliance OFF
– Appliance ON
– Automatic filter cleaning:
– Set the suction output (min -
– Appliance ON
– Automatic filter cleaning:
– Set the suction output (min -
Turning on the Appliance
 Plug in the mains plug.
 Set the rotary switch to the desired pro-
gram.
– 4
EN

Operation

Rotating knob
OFF
max)
ON
max) (eco = energy saver
mode)