Installation; Mounting The Pressure Line (1); Start-Up; Safety - AL-KO TK 250 ECO Betriebsanleitung

Installation

■
Only use extension leads ap-
proved for outdoor use with a
minimum cross-section of
2
1.5 mm . Always fully unwind
cable drums.
■
Damaged or fragile extension
cables may not be used.
■
Check the condition of you
extension cable prior to
every use.
4 INSTALLATION
4.1

Mounting the pressure line (1)

1. Screw the connecting bracket (6) onto the
pump outlet.
2. Screw the combination nipple (5) into the
connecting bracket.
3. Attach the hose to the combination nipple.
NOTE
The combination nipple can be trimmed
to suit the selected hose connection.
Use the largest possible hose diameter.
469927_a

5 START-UP

5.1 Safety

IMPORTANT!
Flood hazard!
In case of pump faults, wa-
ter can leak out and cause
consequential damage due
to flooding.
■
By taking suitable
measures, ensure that
consequential damage
caused by flooding is
prevented in case of
pump malfunctions.
■
Operate the pump hanging
from a cable or ensure the se-
cure mounting of the pump.
■
Operate the pump only if it is
fully immersed.
■
Make sure there is adequate
ground clearance under the
pump.
■
Never allow the pump to run
with a pressure line closed.
■
When using in shafts, make
sure the size is adequate.
■
Always cover the shaft with a
secure foot-plate.
19