Sage Precision Brewer SDC450 Kurzanleitung Seite 3

• Before starting a brew cycle:
− Check that the carafe
drip stop moves up and
down freely.
− Completely empty the carafe
and securely lock the carafe
lid in place.
− Insert and seat the carafe
under the drip stop.
− Ensure the filter basket
is empty and properly fit
in place.
• During a brew cycle:
− Do not remove the carafe or
remove the filter basket while
the unit is in a brew cycle.
Failure to follow the above
may lead to scalding or
serious injury.
• Some surfaces may be hot, use
caution when touching or lifting
the unit or accessories.
• Use only carafe handle when
lifting the carafe.
• The carafe is designed for use
with this appliance only. It must
never be used on a range top or
in a microwave.
• Scalding may occur if the carafe
lid or basket is removed during
the brewing cycle.
CAUTION
• Risk of injury. Proper
installation / removal of basket
is required to reduce the risk of
splashing of hot water.
• Always ensure the carafe lid
is securely locked in place
onto the carafe before pouring.
• Do not use the carafe with
a cracked, loose, weakened
or damaged handle.
• Do not use the filter basket with
a cracked, loose, weakened
or damaged handle.
• Do not touch hot surfaces.
Use the handle for lifting
and carrying the carafe.
• Always wait until the machine
has cooled before removing
the brew basket.
• Do not set a hot carafe on a wet,
cold or heat sensitive surface.
• Always turn the appliance to
the off position, switch off at the
power outlet and unplug at the
power outlet when the appliance
is not in use.
• Do not use harsh or abrasive
materials when cleaning any part
of this appliance such as steel
wool or scoring pads.
• The use of attachments not sold
or recommended by Sage
may cause fire, electric shock
or injuries.
• Always ensure the appliance
is turned OFF, unplugged at
the power outlet and has been
allowed to cool before cleaning,
attempting to move or storing.
• Proper installation of filter
basket, showerhead seal,
and showerhead locking ring
is required to reduce the risk
of splashing of hot water.
EN
®
3