Sage Precision Brewer SDC450 Kurzanleitung Seite 10

• OVER ICE:
1. Fill the tank ensuring the water level does not
exceed the 4 cup level.
2. Fill the brew basket with twice the amount
of coffee you'd normally use for regular
brewed coffee.
3. Brew into the carafe, selecting OVER ICE.
4. Once the brewing cycle is complete, transfer
the coffee to a heatproof pitcher and let cool to
room temperature. Refrigerate until cold, at least
2 hours or overnight. Fill glasses with ice cubes.
Pour the coffee into the glasses, filling them to
within 4cm of the rim. Top each glass with cream,
milk, syrups or sweeteners as desired.
• COLD BREW:
Due to the long duration (typically 4‑14 hours)
of the brewing process we recommend setting
the machine up overnight.
1. Fill the tank with your desired volume of water
ensuring this is below the COLD BREW line.
2. Remove the basket, and ensure both the cone
insert and mesh basket filter are removed. Add
a large paper filter and then coffee at 2-3 times
of regular ratio (approximately 12 scoops for
4 cups). Reinsert the basket into the machine.
3. Remove the lid from the carafe and re‑insert.
4. Navigate to the COLD BREW setting
and press START / CANCEL.
NOTE
OVER ICE mode and COLD BREW mode
will be disabled if there is more than 4 cups
of water in the tank.
SINGLE CUP / SMALLER VOLUMES
(LESS THAN 4 CUPS)
1. Your Sage Precision Brewer will recognise
®
when the brewer has less than 4 cups of water
and will adjust the brew settings, automatically.
Fill your cup with fresh cold water and then pour
it into the water tank, ensuring the water level
stays below the SINGLE CUP line.
10
NOTE
DO NOT fill the water tank more than SINGLE
CUP line or the volume of the cup used to receive
the coffee. It will overflow as the machine brews
until the water tank becomes empty.
2. Place your empty cup underneath the brew
basket outlet.
3. We recommend using cone filter basket insert
for single cups.
4. To change the basket type, rotate the SELECT
dial to Settings and press to enter the Settings
mode and select "Basket Type".
5. Rotate the dial to select "Cone", and press dial
to select. "Cone" will be displayed on the LCD.
6. Insert the Cone filter basket into the brew
basket. Use the alignment marks as a guide.
7. Place a cone shaped paper filter into the cone
filter basket.
8. Grind the correct amount of whole bean coffee
for the amount you are brewing.
9. Select desired brewing mode.
10. Press START / CANCEL to begin brewing.