Using The Refrigerator; Energy Saving Tips - Waeco CoolMatic CRD 50 Bedienungsanleitung

CD50, CRD50
NOTE
I
Always connect the refrigerator to the rectifier. Otherwise the prior-
ity circuit for the refrigerator will be disabled.
The priority circuit reduces the load on a connected battery by the
rectifier always switching to mains operation if AC power is con-
nected.
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Fix the rectifier as shown in the location foreseen, behind the refrigerator
(fig. a, page 7).
➤ Protect the AC circuit using a slow-blow fuse (250 V/4 A).
➤ Connect the power cable to the AC power supply.
➤ Plug in the connecting cable to the AC socket (fig. a 1,page 7).
Proceed as follows when you connect the refrigerator to a DC supply when
a rectifier is fitted:
➤ Connect the loose DC cable (fig. a 2, page 7) to the battery:
– Red cable: positive battery terminal
– Black cable: negative battery terminal
8

Using the refrigerator

NOTE
I
Before starting your new refrigerator for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter "Cleaning and care" on page 43).
8.1

Energy saving tips

 Choose a well ventilated installation location which is protected against
direct sunlight.
 Allow warm food to cool down first before placing it in the device to keep
cool.
 Do not open the cooling device more often than necessary.
 Do not leave the cooler unit open for longer than necessary.
 Defrost your refrigerator as soon as a layer of ice forms.
 Avoid unnecessarily low temperature settings.
 Clean dust and dirt from the condenser at regular intervals.
EN
Using the refrigerator
39