Other Messages - Sony UP-DF500 Bedienanleitung

Error messages Possible causes and remedies
REMOVE FILM TOP The film has jammed around the front
& INNER:J6 or inside the unit.
tOpen the top cover, then the inner
REMOVE FILM The film has jammed near the film
TRAY:J7 tray.
tPull out the film tray and remove
REMOVE FILM The film has jammed at several points.
SOME PLACES:J8 tOpen all of the covers and remove
CALIBRATION The unit takes certain measurements to
INVALID estimate a value for automatic
calibration. However, the correct value
could not actually be measured. The
unit can print, but the automatic
calibration value is not updated.
tTry calibration again. If white strips
MECHA TROUBLE Mechanical trouble has occurred in the
S nn sensor system of the unit.
tTurn off the power once and then
MECHA TROUBLE Mechanical trouble has occurred in the
M nn motor system of the unit.
tTurn off the power once and then
MECHA TROUBLE Mechanical trouble has occurred in the
U nn unit system of the unit.
tTurn off the power once and then
DICOM TROUBLE Trouble has occurred in the DICOM
part of the unit.
tTurn off the power immediately and
TAG INVALID Trouble has occurred in the IC tag part.
tTurn off the power immediately and
10
Messages
cover and remove the jammed
film.(page 12)
the jammed film.(page 13)
the jammed film.(page 13)
or scratches appear on the printout,
clean the thermal head and rollers.
turn it on. The unit may operate
correctly. However, if the message
still remains on the LCD, turn off
the power immediately and contact
your Sony dealer.
turn it on. The unit may operate
correctly. However, if the message
still remains on the LCD, turn off
the power immediately and contact
your Sony dealer.
turn it on. The unit may operate
correctly. However, if the message
still remains on the LCD, turn off
the power immediately and contact
your Sony dealer.
contact your Sony dealer.
contact your Sony dealer.

Other Messages

When the following message appears, the ALARM
indicator does not light. The PRINT indicator blinks.
Messages Possible causes and remedies
HEAD IN COOLING The thermal head has overheated.
tLeave the unit until the head has
PLEASE WAIT
cools down and this message
disappears.
HEAD IN HEATING The thermal head is warming up.
PLEASE WAIT tLeave the unit until the head has
warms up and this message
disappears.
PLEASE WAIT The unit is returning to the initial
settings to restart printing after closing
the covers which opened for removing
jammed film or cleaning.
tLeave the unit until this message
disappears. When this message
appears, the PRINT indicator does
not blink.