Sony UP-DF500 Bedienanleitung Seite 20

3
Remove the packing film on the new cleaning roller
and attach a new cleaning roller.
Insert the right side of the cleaning roller and push it
toward the right. Then push the left side of the cleaning
roller until it is locked.
Notes
• Be careful not to scratch the surface of the
cleaning roller and not to drop it.
• Do not wipe the surface of the cleaning roller
with the supplied wet pad.
4
Close the front cover completely.
If you continue the cleaning of the thermal head and
separation rubber, it is not necessary to close the
front cover. Go to step 2 of the "To clean the
thermal head and separation rubbers" (on page 6)
Note
When you close the cover, be careful not to catch
your fingers or hand with the front cover.
To clean the thermal head and separation
rubbers
Proceed as follows to perform the following cleaning
tasks with the supplied wet pad.
6
Cleaning
1
Pull the lever toward you to open the front cover.
2
Wipe the thermal head with the wet pad.
Note
Before wiping the thermal head, touch the metallic
part of the unit to remove static electricity from
your body.
Thermal head
Wipe the surface of the thermal head gently
with the wet pad.
Notes
• Be careful not to touch the surface of the thermal
head with your hand.
• Do not discard the wet pad. This wet pad is used
for the cleaning tasks to be performed on other
parts of the unit.
• Since the thermal head is still very hot just after
printing is finished, be careful not touch the
thermal head. Touching the hot thermal head may
cause a burn.
3
Close the front cover.
4
Remove the film tray.
You can remove the film tray without pushing the
EJECT TRAY button when the power is off.