Maintenance - Sparky SM 717CE Originalbetriebsanleitung

ACCESSORIES TO BE USED WITH
THIS POWER TOOL
Accessories
Sandpaper discs with various
grit (Fig. 15)
Abrasive net discs with various
grit (Fig. 16)
Diamond discs with various grit
(Fig. 17)
Flexible backing pad (Fig. 18)
and hook-and-loop polishing
pads with various grit (Fig. 19)
VII - Maintenance
WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
16
EN
SM 717CE SMA 717CE
max Ø200 mm max Ø225 mm max Ø200 mm max Ø225 mm
max Ø200 mm max Ø225 mm max Ø200 mm max Ø225 mm
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
During continuous sanding plaster coated sur-
faces the accumulation of dust is possible on
the inner walls of the air-ducts particularly in the
zones where the air changes its direction. To
maintain the optimum state of your power tool
it is necessary to clean it regularly with com-
pressed air and appropriate brush.
or other cleaning agent. Never use caustic
agents to clean plastic parts.
into contact with the tool.
IMPORTANT! To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
SM 717CE ● SMА 717CE ● SM 712CE ● SMА 712CE
SM 712CE
max Ø7" (max 0,5 kg)
max Ø7"
WARNING: Never use alcohol, petrol
WARNING: Water must never come
SMA 712CE