Maintenance - Ferm AGM1065S Übersetzung Der Originalbetriebsanleitung

3. OPERATING
Make sure that the work piece is properly
supported or fixed and keep the supply
cord routing away from the work area.
Switching on and off (Fig. A)
• T o switch the machine on, press the lock-off
button (5) to the front and then press the On/
off switch (6).
• T o switch the machine off, release the On/off
switch (6).
Hold the machine away from the work piece when
turning it on and off because the wheel disc could
damage the work piece.
• C lamp the work piece firmly or use another
method to ensure that it cannot move while
working.
• C heck the discs regularly. Worn wheel discs
have a negative effect on the machine's efficien-
cy. Change to a new wheel disc in good time.
• A lways first turn the machine off after use
before removing the plug from the socket.
Deburring (Fig. E)
An angle of inclination of 30º to 40º will give the
best results when deburring. Move the machine
back and forth using light pressure. This will
prevent the work piece from discolouring or
becoming too hot and will avoid making groves.
Never use abrasive cutting discs for
deburring work!
Cutting (Fig. F)
For cutting, a special protection guard must be
used (not included).
Maintain firm contact with the work piece to
prevent vibration and do not tilt or apply pressure
and when cutting. Use moderate pressure when
working, appropriate to the material that is
being worked on. Do not slow down wheel discs
by applying sideways counter pressure. The
direction in which you want to cut is important.
The machine must always work against the
direction of the cut; so never move the machine
in the other direction! There is the risk that the
machine will catch in the cut causing kickback
and that you will lose control.
10
Hints for optimum use
• C lamp the work piece. Use a clamping device
for small work pieces.
• H old the machine with both hands.
• S witch on the machine.
• W ait until the machine has reached full speed.
• P lace the wheel disc on the work piece.
• S lowly move the machine along the work
piece, firmly pressing the wheel disc against
the work piece.
• D o not apply too much pressure on the
machine. Let the machine do the work.
• S witch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.

4. MAINTENANCE

Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important
that it is correctly destroyed and replaced by
an approved BS 1363/7A fused plug and that
the following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
• blue neutral
• brown live
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
• T he wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
• T he wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.