Ferm AGM1065S Übersetzung Der Originalbetriebsanleitung Seite 9

Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-4
Fig. A & C
1. Spindle lock button
2. Release lever for protection guard
3. Protection guard (fig. D1+D2)
4. Carbon brush cover
5. Lock-off button
6. On/Off switch
7. Side handle connection point
Fig. B
8. Spindle
9. Mounting flange
10. Wheel disc (not included)
11. Clamping nut
12. Spanner
13. Side handle
Fig. C1 & D1
Protection guard for grinding
Fig. C2 & D2
Protection guard for cutting ( not included )
Fig. G
14. Carbon brush holder
15. Carbon brush
Assembly
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the protection guard
(Fig. C and D)
• P lace the machine on a table w ith the spindle
(8) facing upwards.
• P lace the protection guard (3) over the
machine head as shown in Figure C making
sure the ridges on the protection guard fall into
the notches of the machine head.
• T urn the protection guard counter clockwise as
shown in Figure D and clench the release lever
for protection guard (2).
• Y ou can adjust the position of the protection
guard by releasing the lever (2), adjust the
guard to the desired position and clench the
lever to lock it.
Never attempt to remove the guard.
Mounting and removing the wheel disc
(Fig. B)
• A lways use suitable wheel disc for this
machine with diameter Ø 115mm and a bore
from 22.2 mm the thickness of the wheel disc
should be 6 mm for wheel disc for grinding and
3 mm for wheel disc for cutting, the mounting
wheel disc may not touch the safety guard.
Mounting
• P lace the machine on a table with the
protection guard (3) facing upwards.
• M ount the flange (9) onto the spindle (8).
• P lace the wheel disc (10) onto the spindle (8).
• K eep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) onto the
spindle (8) by using the spanner (12).
Removing
• P lace the machine on a table with the
protection guard (3) facing upwards.
• K eep the spindle lock button (1) pressed and
loosen the clamping nut (11) using the spanner
(12).
• R emove the wheel disc (10) from the spindle
(8).
• K eep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) using the
spanner (12).
Mounting the side handle
(Fig. A and B)
• T he side handle (13) can be screwed into one
of the three side handle connection point (7).
9