Cinema Controller Von Dpxk-Xxblp - Barco DP4K-23BLP Benutzer- Und Installationshandbuch

8. Eingänge und Kommunikation
Integrated Media Server (IMS)
Abbildung 8-8
IMS-Beispiel von Doremi.
Konfigurations- und Betriebsanweisungen für IMB und IMS sind in diesem Dokument nicht enthalten. Tech-
nische Dokumentation und Support siehe Website des Herstellers des installierten IMB/IMS.
8.7

Cinema Controller von DPxK-xxBLP

Location of the communication ports
1 2
LAN
Abbildung 8-9
Functionality
Local Area Network (LAN: 10/100/1000 base-T) port
1
Local Area Network (LAN: 10/100/1000 base-T) with built-in Ethernet switch (port 1 and port 2). Use for projector control
and automation. E.g. Touch Panel, content server, ... (not for content streaming!)
As there is a need to daisy chain projectors when they are on an Ethernet network, an Ethernet switch is built in. the
incoming network is hereby available for the internal PC and for the next device in the chain. In this way a 'star' network
interconnection can be avoided. The switch used is a stand alone 10/100/1000Mbit Ethernet switch. This assures no
influence on the network speed. Furthermore, this Ethernet switch remains operational when the projector is in Standby
mode.
The connectors used for these Ethernet ports are of the type RJ45, which is compatible with standard RJ45 cable connector.
Straight (most common) as well as cross linked network cables can be used. The 2 ports are functionally identical. Both
ports are connected via the projector switch (Auto sensing enabled).
Wide Area Network (WAN) port
2
Wide Area Network (WAN: 10/100/1000 base-T). Use this Ethernet port (reference 2 Abbildung 8-9) to connect the network
which contains the DHCP server.
The DPxK BLP series projector can be connected to a WAN (Wide area network) (reference 2 Abbildung 8-9). Once
connected to the WAN, users can access the projector from any location, inside or outside (if allowed) their company
network using the Communicator software. This software locates the projector on the network if there is a DHCP server or
the user can insert the correct IP-address to access the projector. Once accessed, it is possible to check and manipulate all
the projector settings. Remote diagnostics, control and monitoring of the projector can then become a daily and very simple
operation. The network connectivity allows detection of potential errors and consequently improves service time.
96
WAN DVI IN A
3 4
RS 232 IN
DVI IN B USB 2.0
5 6 7
3D INTERFACE PERIPHERAL PORT
GENERAL INTERFACE I/0
R5906753DE DPXK BLP SERIES 25/01/2018