Operation; Preparing The Appliance - Silvercrest SRGS 1300 B2 Bedienungsanleitung

RP100110 Raclette mit heißem Stein LB6so Seite 8 Freitag, 13. Juni 2014 4:23 16
2. Check that the appliance shows no signs
of damage.
3. Remove any labels or stickers (but not
the type plate on the underside).
4. Clean the appliance before using it for
the first time. Observe the information in
the section entitled "7. Cleaning" on
page 11.
5. Select a location that is firm, level and
not flammable. Maintain a distance of
approx. 50 cm from other objects.
6. Turn the temperature regulator 4 to "0".
This switches the heater off.
7. Insert the mains plug into a suitable wall
socket which complies with the technical
data.

6.1 Preparing the appliance

1. Select a location that is firm, level and
not flammable. Maintain a distance of
approx. 50 cm from other objects.
2. Turn the temperature regulator 4 to "0".
This switches the heater off.
3. Grease the raclette pans lightly 8 on the
inside.
Note: Use kitchen paper dipped in a
little cooking oil.
4. Lightly grease the top surface of the
stone grill plate 1 and grill plate 2
(Version A only).
Note: Do not use too much oil as this
could catch fire and burn. Spread the oil
carefully using a cooking brush or
kitchen paper.
8
The red indicator light 3 comes on.
8. Turn the temperature regulator 4 to
MAX.
The green indicator light 5 lights up, and
the appliance starts to heat up.
9. Leave the appliance switched on for
around 10 - 15 minutes.
10.Switch the heater off by turning the
temperature regulator 4 to "0".
11. Take out the mains plug and allow the
appliance to cool down.
12. Clean the appliance again. Observe the
information in the section entitled
"7. Cleaning" on page 11.

6. Operation

5. Place the stone grill plate 1 and grill
plate 2 (Version A only) on the
appliance.
Note: The grooves on the stone grill
plate 1 must face up. The grill plate 2
(Version A only) can be used on both
sides.
6. Insert the mains plug into a suitable wall
socket which complies with the technical
data.
The red indicator light 3 comes on.
7. Turn the temperature regulator 4 to
MAX.
The green indicator light 5 lights up, and
the appliance starts to heat up.
8. Allow the appliance heat up for around
10 minutes.
Note: The stone grill plate 1 requires
around 30 minutes to heat up.
The appliance is now ready to use.