Measuring; Saving The Results - Mettler Toledo Densito 30PX Bedienungsanleitung

6.4

Measuring

The procedure is dependent upon the settings in the menu, see Chapter 5.4.
The symbol appears in the display: Measuring with automatic stability
control
- Press the ok/meas. key to start measuring.
The symbol blinks during measurement. The result appears in reverse display.
The symbol does not appear on the display: Measuring with manual stability
control
The instrument measures continuously.
- Wait until the displayed value stabilizes.
- If the result is to be saved: Press the ok/meas. key.
The result appears in reverse display.
Measuring with temperature-compensation coefficients (α)
(Comp. Density, SG, Conc. or Baume on the display)
- Press the key until a previously-saved temperature-compensation coeffi-
cient appears in the display, e.g.
- Select the desired coefficient using the
- Confirm the selected coefficient with the ok/meas. key.
- Measure using either automatic or manual stability control.
Emptying the measuring cell
- Hold the sample tube over a waste container.
- Press drain button (3) downward slowly and move it up again with the fill
button (12).
6.5

Saving the results

The instrument can save up to 1100 results internally. Each time a result is
saved, the number of internally-stored values increases by one.
The procedure for saving the results is dependent upon the settings in the menu
(see Chapter 5.4).
The symbol appears in the display: Saving all results automatically
The instrument saves all results automatically.
The symbol does not appear in the display: Saving selected results manually
Save the result:
- Press the ok/meas. key.
Do not save the result:
- Press the esc key.
METTLER TOLEDO Densito 30PX
α1=0.132 .
and keys.
Measurement (meas)
15