Tutorial; Inserting Batteries; Configuration - Mettler Toledo Densito 30PX Bedienungsanleitung

Tutorial

4 Tutorial
4.1

Inserting batteries

- Open the battery compartment cover on the back of the Densito 30PX.
- Remove battery compartment.
- Insert batteries into the battery compartment, observing correct polarity.
- Insert battery compartment, ensuring that the contacts of the battery compart-
ment face the instrument.
- Close battery compartment cover.
The instrument switches on automatically and is immediately ready for operation.
With the backlighting switched off the battery lasts about 90 hours.
If nothing appears in the display
- Check polarity of the batteries and battery compartment.
4.2

Configuration

Configuring the instrument for test measurement.
Entering the menu
- Press the keys ok/meas. and esc simultaneously.
The instrument switches to the FUNCTION menu,
in reverse display (white on black).
Selecting setting
- Confirm
Measure Unit
key repeatedly until SG(t/t) is marked.
- Press the
- Confirm
SG (t/t)
Setting date and time
key to switch to Date & Time.
- Use the
- Confirm
Date & Time
- To set the date, confirm
- Use the side arrows to select the number to change, and use the up and down
arrows to change the value. Confirm with ok/meas.
- Use the down arrow key to switch to Time and confirm with ok/meas. Set the
time as described above.
Exiting the menu
- Press the esc key.
The instrument is configured for test measurement.
6
by pressing the ok/meas. key.
by pressing the ok/meas. key.
with the ok/meas. key.
with the ok/meas. key.
Date
Measure Unit
METTLER TOLEDO Densito 30PX
appears