Attaching The Pillion Unit To The Helmet - Silvercrest SMFB 2.1 A1 Bedienungsanleitung

GB
IE

Attaching the pillion unit to the helmet

10
5) Place two of the Velcro fastening points
speakers . Ensure that you attach these in a position that corresponds
9
to that of the ears of the person wearing the helmet. Remove the protective
fi lm from the rear of the Velcro fastening points
desired location.
NOTE
► If the lining of the helmet holds the speakers
fastening points
23
points .
23
6) Press the speakers
9
7) Push the cable a little way beneath the helmet padding if possible.
Fig. 1
Install the pillion unit in the helmet (see Fig. 1):
1) Place the Velco fastening point for the pillion unit
the microphone
17
the rear of the Velcro fastening point
Place two of the Velcro fastening points
speakers of the pillion unit. Ensure that these are attached in a position
18
that roughly corresponds to that of the ears of the person wearing the helmet.
Remove the protective fi lm from the rear of the Velcro fastening points
and affi x these in the desired locations.
2) Press the speakers
18
Press the pillion unit onto the Velcro point for the pillion unit
the microphone
17
3) Push the cable a little way beneath the helmet padding if possible.
23
, then you will not need to use the Velcro fastening
onto the Velcro fastening points
is pointing forwards. Remove the protective fi lm from
and affi x it in the desired location.
25
23
onto the Velcro fastening points
is pointing forwards.
inside the helmet to attach the
and affi x these in the
23
even without the Velcro
9
inside the helmet.
23
into the helmet so that
25
inside the helmet to attach the
inside the helmet.
23
. Ensure that
25
SMFB 2.1 A1
23